This is a replacement hood release cable handle constructed in billet 6061 aluminum for 1971-1976 Caprice and Impalas the DONKS. It is made from a solid piece of aluminum with high polished to compliment your ride. The original is a rubber that deteriorates and brakes apart and looks terrible from age and neglect.

TOOLS NEEDED FOR INSTALL:

1. Cut off Wheel

2. 3/32 Allen wrench for set screws

3. Pliers

INSTALL INSTRUCTION

1. remove old handle by cutting slits in it with the cutoff wheel and break it off the steel square shaft. More slits make it easier to break pieces off.

2. slide handle over and tighten set screws. putting small dimples were the set screw touch will ensure a strong bite of the set screw.

THIS INSTALL IS MODERATELY MORE DIFFICULT THAN THE BRAKE RELEASE CABLE VERSION. WE RECOMMEND PROFESSIONALS TO INSTALL ALL PRODUCTS. FOR SHOW USE ONLY

AFTER RECEIVING YOUR PRODUCT, MAKE SURE TO WIPE DOWN AND CLEAN IT WITH ALUMINUM POLISH/WINDEX AND A SOFT MICROFIBER CLOTH

PRODUCTS THAT HAVE BEEN HANDLED ARE SUBJECT TO A RESTOCKING FEE BASED ON RETURNED CONDITION - UP TO 20%